PROC m_fl_amon
;Version 3
GOTO BEGIN
;
;#**************************************************************************
;#	****PROCEDURE HEADER****
;#
;# 	1.0 	Introduction
;#
;#		1.1	FOT Name:     m_fl_amon
;#		   	MMS-F Name:  	 m_amon
;#		   	SUM Issue:   	
;#			Simulator Validation Status:
;#
;#		1.2	Date Created:  01-09-95
;#			    Revision:  1. 04-24-95 GJ
;#						2. 05-04-95 RR
;#						3. 11-18-95 GJ
;#
;#		1.3	Change Description:	
;#
;#			1.  Removed wait.  Send AM reset commands together.
;#			2.  Changed comments.
;#			3.  Changed naming convention from m_ts_* to m_fl_*.
;#
;#		1.4	Point of Contact:	RROWE
;#			FOT Author:  RROWE	ATSC/SOHO	805-3642
;#
;#**************************************************************************
;#	2.0	Description
;#
;#		2.1	Narrative Description
;#
;#			THIS PROCEDURE POWERS UP AND INITIALIZES THE MDI ALIGNMENT
;#			MECHANISM AS PART OF M_ON OR M_WAKE.
;#
;#		2.2	Intended Use:
;#
;#			CONTROLLED INITIAL POWER ON OF MDI AM SUBSYSTEM
;#
;#		2.3	Duration:	TBD
;#
;#		2.4 References:
;#
;#**************************************************************************
;#	3.0	Instructions for Use:
;#
;#		3.1	Parameters Required
;#
;#			None
;#
;#		3.2	Critical Activities
;#
;#			TBD
;#
;#		3.3	Special Constraints or Activities
;#
;#			MDI IN SLEEP MODE.  MEDIUM RATE TELEMETRY SUPPORT REQUIRED FOR
;#			DURATION OF POWER ON SEQUENCE.  MDI OPERATOR ON STATION TO SUPPORT
;#			VERIFICATION OF PROCEDURE.
;#**************************************************************************
;#	4.0	STEPS:

BEGIN:

IF (P@CMD_STATE#TELECOMMAND = "AVAILABLE") THEN
ELSE
	/CLEAR		;Clearing the Command Buffer.
ENDIF

IF(P@KKTMMODE =  "HK") THEN	;Check TM is at least in MR
WRITE "TM IS NOT AT LEAST IN MEDIUM RATE."
GOTO END
ENDIF

SV P@MIPWA
SV P@MIPWB
WAIT;	RECORD THE MDI CURRENT.  SHOULD BE <2.0

WAIT;	'GO' TO RESET AM

/MBAM1RS;		RESET AM1

/MBAM2RS;		RESET AM2
/SEND

WAIT;	'GO' TO POWER ON AM

/MBPWAMON;	POWER ON AM
/SEND

WAIT UNTIL(P@MKPWAM="ON");	VERIFY POWER ON

SV P@MXAM1POS
SV P@MKAM1CMD
SV P@MXAM2POS
SV P@MKAM2CMD
WAIT; RECORD THE INITIAL POSITION

WAIT;	'GO' TO MOVE ALIGNMENT MECHANISM +/-2 STEPS TO REMOVE HYSTERESIS

S M_FL_AMRESET

SV P@MIPWA
SV P@MIPWB
WAIT;	RECORD MDI CURRENT

;#************************************************************************** 
;#	5.0	Final Constraints
;#
;#		TBD
;#
;#**************************************************************************
end:
ENDPROC