# Name: M_CCDSPT
#
# Date:
#
# created:	09 01 1994	SDW
# revisions:	
#
# Change Description
#
# None
#
# MDI Author:	Scott Williams	415-725-0482
#
# Description
#
# This procedure configures the set point for the Operational CCD heater 
# controller.
#
# Parameters
#
# 1) P1 - set point value, 3 bits (0 to 7) where 0 is no power and
#    7 is maximum power
#
# Intended Use
#
# Setting the MDI Operational CCD controller set point
#
# Duration
#
# ?
#
# Requirements and Constraints
#
# MDI in SLEEP or higher mode.  Medium rate telemetry support required for
# duration of power on sequence.  MDI Operator on station to support
# verification of procedure.  MDI operator verification required for
# each step before continuing.  
#
# Steps
#
# Step	Description				Command	   Monitor  Value
#	record MDI current, either			   MIPWA     <1.5
#	or						   MIPWB     
#  2	HOC set point to P1			mbhcmspt   mkhcmspt   P1
#		mbhcmspt P1
#  3	record MDI current, either			   MIPWA     +0.3
#	or						   MIPWB     
#  4	record CCD temperature				   QTMI1D
#  5    end of procedure