# Name: M_OVENSPT
#
# Date:
#
# created:	09 01 1994	SDW
# revisions:	
#
# Change Description
#
# None
#
# MDI Author:	Scott Williams	415-725-0482
#
# Description
#
# This Procedure sets the prime oven set point
#
# Parameters
#
# 1) P1 - prime oven set point, 3 bit value (0 to 7) where 0 corresponds
#    to approximately 33 degC and 7 corresponds to approximately 41 degC.
#
# Intended Use
#
# Establish prime oven set point for thermal control
#
# Duration
#
# ?
#
# Requirements and Constraints
#
# MDI in SLEEP mode.  Medium rate telemetry support required for
# duration of power on sequence.  MDI Operator on station to support
# verification of procedure.  MDI operator verification required for
# each step before continuing.  
#
# Steps
#
# Step	Description				Command	   Monitor  Value
#  1	record MDI current, either			   MIPWA     +0.4
#	or						   MIPWB     
#  2    HPO set point to P1			mbhpospt   mkhpospt  P1
#		tcblock mbhpospt  P1
#  3	record MDI current, either			   MIPWA     +0.4
#	or						   MIPWB     
#  4	record oven temperature				   mtopts4
#							   mtopts5
#  5    end of procedure