PROC C_FL_MCUOFF
;Version 3
GOTO BEGIN
;
;#**************************************************************************
;#	****PROCEDURE HEADER****
;#
;# 	1.0 	Introduction
;#
;#		1.1	FOT Name: 	C_FL_MCUOFF
;#		   	CDS Name: 	CDS_MCU2
;#		   	CDS Issue:	
;#			Simulator Validation Status: COBS level only.
;#
;#		1.2	Date Created:  17-MAY-95
;#			    Revision:  1. 03-JUN-95	BS
;#						2. 07-AUG-95	MH
;#                            3. 27-OCT-95   TFM
;#		1.3	Change Description:	
;#
;#			1. Add tm check for C+EM12V.
;#			2. Add intended use, duration, page references
;#             3. Changed ts in name to fl.
;#		1.4	Point of Contact:	CCazeau
;#			FOT Author:  MHill	ATSC/SOHO	286-4799
;#
;#**************************************************************************
;#	2.0	Description
;#
;#		2.1	Narrative Description
;#
;#			This procedure is derived from C_TS_MCU2 section 28 for GSCT2.
;#
;#		2.2	Intended Use:
;#
;#			Power OFF CDS MCU.
;#
;#		2.3	Duration:	2 min
;#
;#		2.4	References: page C_CDS_STATUS_HK
;#
;#**************************************************************************
;#	3.0	Instructions for Use:
;#
;#		3.1	Parameters Required
;#
;#			None
;#
;#		3.2	Critical Activities
;#
;#			None
;#
;#		3.3	Special Constraints or Activities
;#
;#			None
;#**************************************************************************
;#	4.0	STEPS:

BEGIN:

IF (p@CMD_STATE#TELECOMMAND = "AVAILABLE") THEN
ELSE
	/CLEAR		;Clearing the Command Buffer.
ENDIF

;******SECTION 28******

;SWITCH DOWN ALL MCU POWER
/CBEHTRSF		;OP Heaters OFF
/CBEM12VF		;MCU +/- 12V OFF
/CBEM5VF		;MCU +5V OFF
WAIT			;Verify command buffer contents
/SEND
WAIT UNTIL (p@CSEM5V = "OFF")
WAIT UNTIL (p@'C+EM12V' < 0.3)

OUT:
;#************************************************************************** 
;#	5.0	Final Constraints
;#
;#		None
;#
;#**************************************************************************
RETURN
ENDPROC