PROC F_FL_ALSEN_SB
; VERSION 2

IF (P@NRT_STATE#TELECOMMAND = "ENABLED") THEN
/NRT TPUT PAUS
ELSE
ENDIF

GOTO BEGIN
;
;#**************************************************************************
;#	****PROCEDURE HEADER****
;#
;# 	1.0 	Introduction
;#
;#		1.1	FOT Name:   F_FL_ALSEN_SB
;#		   	MMS-F Name:  	 
;#		   	SUM Issue:   	
;#			Simulator Validation Status:
;#
;#		1.2	Date Created:  05-MAY-95  BS
;#			    Revision:  1. 18-MAY-95  BS
;#						2. 25-OCT-95  BB
;#
;#		1.3	Change Description:	
;#
;#			1. Add TSTOL cmds to allow procedure to be run as RPR.
;#			2. Changed proc name from TS to FL. Updated version number.
;#
;#		1.4	Point of Contact:	
;#			FOT Author: BSAPPER 	ATSC/SOHO	286-4799
;#
;#**************************************************************************
;#	2.0	Description
;#
;#		2.1	Narrative Description
;#
;#			PUT CELIAS IN STANDBY MODE
;#
;#		2.2	Intended Use:
;#
;#			Put all 3 CELIAS sensors (MTOF,CTOF,STOF) into standby mode.
;#
;#		2.3	Duration:	TBD
;#
;#		2.4 References:
;#
;#**************************************************************************
;#	3.0	Instructions for Use:
;#
;#		3.1	Parameters Required
;#
;#			None
;#
;#		3.2	Critical Activities
;#
;#			TBD
;#
;#		3.3	Special Constraints or Activities
;#
;#			TBD
;#**************************************************************************
;#	4.0	STEPS:
	
BEGIN:

IF (P@CMD_STATE#TELECOMMAND = "AVAILABLE") THEN
ELSE
	/CLEAR		;Clearing the Command Buffer.
ENDIF

/FBCMOD1I					;Power on CTOF to Standby mode immediate
WAIT				;VERIFY BUFFER CONTENTS
/SEND

WAIT UNTIL (P@FSDMODC = "Standby")

/FBMMOD1I					;MTOF power on (standby mode)
WAIT				;VERIFY BUFFER CONTENTS
/SEND

WAIT UNTIL (P@FSDMODM = "Standby")

/FBSMOD1I						;STOF power on (standby)
WAIT				;VERIFY BUFFER CONTENTS
/SEND

WAIT UNTIL (P@FSDMODS = "Standby")

WAIT UNTIL (P@CMD_STATE#TELECOMMAND = "AVAILABLE")
;#************************************************************************** 
;#	5.0	Final Constraints
;#
;#		TBD
;#
;#**************************************************************************

IF (P@NRT_STATE#TELECOMMAND = "PAUSE-ENAB") THEN
/NRT TPUT RSUM
/CMSMSG,CELIAS,'Procedure F_TS_ALSEN_SB has completed'
ELSE
ENDIF
ENDPROC