PROC F_FL_MDIAG_ON
; VERSION 1
GOTO BEGIN
;
;#**************************************************************************
;#	****PROCEDURE HEADER****
;#
;# 	1.0 	Introduction
;#
;#		1.1	FOT Name:   F_FL_MDIAG_ON 
;#		   	MMS-F Name:  	 
;#		   	SUM Issue:   	
;#			Simulator Validation Status:
;#
;#		1.2	Date Created:  04-MAY-95  BS
;#			    Revision:	1. 25-OCT-95  BB
;#
;#		1.3	Change Description:	
;#
;#			1. Changed proc name from TS to FL. Updated version number.
;#
;#		1.4	Point of Contact:	
;#			FOT Author:BSAPPER  	ATSC/SOHO	286-4799
;#
;#**************************************************************************
;#	2.0	Description
;#
;#		2.1	Narrative Description
;#
;#			MTOF to IFC mode.
;#
;#		2.2	Intended Use:
;#
;#			To put the MTOF sensor into in-flight-calibration (IFC) mode.
;#
;#		2.3	Duration:	TBD
;#
;#		2.4 References:
;#
;#**************************************************************************
;#	3.0	Instructions for Use:
;#
;#		3.1	Parameters Required
;#
;#			None
;#
;#		3.2	Critical Activities
;#
;#			TBD
;#
;#		3.3	Special Constraints or Activities
;#
;#			The procedures  F_TS_PWRON_PR and F_TS_MTOF_ON have been run.
;#			NOTE: F_TS_MTOF_ON may have been run as a part of another proc.
;#
;#**************************************************************************
;#	4.0	STEPS:

BEGIN:

IF (P@CMD_STATE#TELECOMMAND = "AVAILABLE") THEN
ELSE
	/CLEAR		;Clearing the Command Buffer.
ENDIF

IF (P@FSDMODM = "Power Off")THEN
	WRITE "*****MTOF SENSOR DOES NOT APPEAR TO BE ON*****"
	ASK "DO YOU NEED TO TURN ON MTOF"
	ANSWER = %UPPER(ANSWER)
	IF (ANSWER = "Y")THEN
		/FBMMOD1I					;MTOF power on (standby mode)
		WAIT				;VERIFY BUFFER CONTENTS
		/SEND

		WAIT UNTIL (P@FSDMODM = "Standby")
	ENDIF
ENDIF

/FBMMOD4			;Set MTOF to IFC mode. 1 cycle takes 2.5 min.
				;Cycle starts at a new record (every 5 min.)
WAIT			;VERIFY BUFFER CONTENTS
/SEND

WAIT	;VERIFY WITH EXPERIMENTER COMMAND SUCCESSFUL(MTOF and DPU HK TLM)

;#************************************************************************** 
;#	5.0	Final Constraints
;#
;#		TBD
;#
;#**************************************************************************
ENDPROC