PROC F_FL_SNOMINAL
;Version 1
 GOTO BEGIN
 ;
 ;#***********************************************************************
 ;#	****PROCEDURE HEADER****
 ;#
 ;#	1.0	Introduction
 ;#
 ;#		1.1	FOT Name: F_FL_SNOMINAL 
 ;#			MMS-F Name:
 ;#			SUM Issue:
 ;#			Simulator Validation Status
 ;#
 ;#		1.2	Date Created: 17-SEP-95 WB
 ;#			 Revision: 1.	5-JAN-95
 ;#
 ;#			1. Removed Enabling of STOF sweep, Sweep 1 on, Sweep 2 on.
 ;#			per 12/18/95 MOCR - per STOF lead CO-I
 ;#
 ;#		1.3	Change Description:
 ;#
 ;#		1.4	Point of Contact:
 ;#			    Author: W.Bornemann MPE 49-89-3299-3842
 ;#***********************************************************************
 ;#	2.0	Description
 ;#
 ;#		2.1	Narrative Decription
 ;#			Set STOF to nominal mode.
 ;#
 ;#		2.2	Intended Use:
 ;#
 ;#		2.3	Duration:	TBD
 ;#
 ;#		2.4	References:
 ;#
 ;#***********************************************************************
 ;#	3.0	Instructions for Use:
 ;#
 ;#		3.1	Parameters Required
 ;#
 ;#		None
 ;#	3.2	Critical Activities
 ;#
 ;#
 ;#		None
 ;#
 ;#	3.3	Special Constraints or Activities
 ;#          Check of limits required !!!
 ;#          STOF has to be in manual mode first
 ;# *************************************************************************	
 ;#	4.0	STEPS:

 BEGIN:

 IF (P@CMD_STATE#TELECOMMAND = "AVAILABLE") THEN
 ELSE
 	/CLEAR	;Clearing the Command Buffer.
 ENDIF

 /FBSEVS,7804              ;Set EVS control
 WAIT               ;VERIFY BUFFER CONTENTS
 /SEND

WAIT UNTIL (P@CMD_STATE#TELECOMMAND = "AVAILABLE") 
WAIT 5
 /FBSSDIAG,0F00            ;Set Diagnostic control (DblCo on)
 WAIT               ;VERIFY BUFFER CONTENTS
 /SEND

WAIT UNTIL (P@CMD_STATE#TELECOMMAND = "AVAILABLE") 
 /FBSMOD5                  ;STOF nominal mode
 WAIT              ;VERIFY BUFFER CONTENTS
 /SEND

 WAIT UNTIL (P@FSDMODS = "Nominal")

 ;#***********************************************************************
 ;#   5.0   Final Constraints
 ;#		None
 ;#
 ;#***********************************************************************
 ENDPROC