PROC F_FL_STIM_H 
 GOTO BEGIN
 ;
 ;#***********************************************************************
 ;#	****PROCEDURE HEADER****
 ;#
 ;#	1.0	Introduction
 ;#
 ;#		1.1	FOT Name: F_FL_STIM_H
 ;#			MMS-F Name:
 ;#			SUM Issue:
 ;#			Simulator Validation Status
 ;#
 ;#		1.2	Date Created: 17-SEP-95 WB
 ;#			 Revision: 
 ;#
 ;#		1.3	Change Description:
 ;#
 ;#		1.4	Point of Contact:
 ;#			    Author: W.Bornemann MPE 49-89-3299-3842
 ;#***********************************************************************
 ;#	2.0	Description
 ;#
 ;#		2.1	Narrative Decription
 ;#			Stimulation TAC/POS HSTOF.
 ;#
 ;#		2.2	Intended Use:
 ;#
 ;#		2.3	Duration:	TBD
 ;#
 ;#		2.4	References:
 ;#
 ;#***********************************************************************
 ;#	3.0	Instructions for Use:
 ;#
 ;#		3.1	Parameters Required
 ;#
 ;#		None
 ;#	3.2	Critical Activities
 ;#
 ;#
 ;#		TBD
 ;#
 ;#	3.3	Special Constraints or Activities
 ;#
 ;#
 ;# *************************************************************************	
 ;#	4.0	STEPS:

 BEGIN:

 IF (P@CMD_STATE#TELECOMMAND = "AVAILABLE") THEN
 ELSE
 	/CLEAR	;Clearing the Command Buffer.
 ENDIF

 /FBSLIMST,0000            ;Stof Sweep Step 1st step = 0, last step = 0
 WAIT
 /SEND             ;VERIFY BUFFER CONTENTS

WAIT UNTIL (P@CMD_STATE#TELECOMMAND = "AVAILABLE")
/FBSGRP1,3400,3000,2C00,2803,2400,2000,1C00,1860,1400,1037,0C00,0821,0400,02FF
 WAIT               ;VERIFY BUFFER CONTENTS
 /SEND

WAIT UNTIL (P@CMD_STATE#TELECOMMAND = "AVAILABLE") 
/FBSIFC,E404,0000  ;Set data I/F control
 WAIT               ;VERIFY BUFFER CONTENTS
 /SEND

WAIT UNTIL (P@CMD_STATE#TELECOMMAND = "AVAILABLE")
 /FBSCAL,80D0            ;Set internal calibration control
 WAIT               ;VERIFY BUFFER CONTENTS
 /SEND

WAIT UNTIL (P@CMD_STATE#TELECOMMAND = "AVAILABLE")
 /FBSEVS,7804            ;Set EVS control
 WAIT               ;VERIFY BUFFER CONTENTS
 /SEND

WAIT UNTIL (P@CMD_STATE#TELECOMMAND = "AVAILABLE")
 /FBSPOS,7000            ;Set POS enable
 WAIT               ;VERIFY BUFFER CONTENTS
 /SEND


WAIT UNTIL (P@CMD_STATE#TELECOMMAND = "AVAILABLE")
 /FBSMOD2I                ;STOF manual mode
 WAIT              ;VERIFY BUFFER CONTENTS
 /SEND

 WAIT UNTIL (P@FSDMODS = "Manual")

 ;#***********************************************************************
 ;#   5.0   Final Constraints
 ;#
 ;#         TBD
 ;#
 ;#***********************************************************************
 ENDPROC