PROC H_FL_EBACKUP
;version 4
GOTO BEGIN
;
;#**************************************************************************
;#	****PROCEDURE HEADER****
;#
;# 	1.0 	Introduction
;#
;#		1.1	FOT Name: H_FL_EBACKUP   
;#		   	MMS-F Name: H_FL_EBACKUP
;#		   	SUM Issue: N/A  	
;#			Simulator Validation Status: Validated
;#
;#		1.2	Date Created: 6 MAR 1995    TL 
;#			    Revision: 1) 5 APR 19   TL
;#                           2) 24 APR 19  TL
;#                           3) 11 Aug 95  TL
;#                           4) 25 Oct 95  TL
;#
;#		1.3	Change Description:	
;#
;#			1) Changed parameters, added one HBEUPLD3 command.
;#             2) Added WAIT and SEND commands at line 76. (4/24)
;#             3) Changed name to _FL_ (FLight ready).
;#             4) Added version number, comments.
;#
;#		1.4	Point of Contact: T. LA FAVE	
;#			FOT Author: T. LA FAVE 	ATSC/SOHO	286-4799
;#
;#**************************************************************************
;#	2.0	Description
;#
;#		2.1	Narrative Description
;#
;#			This module will switch ESU from ON mode through 
;#             MAINTENANCE mode to one of the basic BACKUP modes
;#             (only HED sensor ON).
;#
;#		2.2	Intended Use:
;#
;#			
;#
;#		2.3	Duration:	7 min.
;#
;#		2.4 References:
;#             Pages h_cepac1
;#**************************************************************************
;#	3.0	Instructions for Use:
;#
;#		3.1	Parameters Required
;#
;#			None
;#
;#		3.2	Critical Activities
;#
;#			None
;#
;#		3.3	Special Constraints or Activities
;#
;#			None
;#**************************************************************************
;#	4.0	STEPS:

BEGIN:

IF (P@CMD_STATE#TELECOMMAND = "AVAILABLE") THEN
ELSE
	/CLEAR		;Clearing the Command Buffer.
ENDIF

WAIT UNTIL (P@HSEMODE = "ON")

/HBEUPLD3,4CA2,FF80,0000    ; Upload data
WAIT                        ; Verify command buffer contents
/SEND

WAIT UNTIL (P@HSEMODE = "MAINTENANCE")

WAIT UNTIL (P@CMD_STATE = "AVAILABLE")
/HBEUPLD3,4CA2,2B00,0100    ; Upload data
/HBEUPLD3,4CA2,3600,0000    ; Upload data
WAIT                        ; Verify command buffer contents
/SEND
WAIT 60
/HBECNFHW                   ; Configure hardware
/HBEUPLD3,4CA2,FF00,0000    ; Upload data
WAIT                        ; Verify command buffer contents
/SEND

WAIT UNTIL (P@HSEMODE = "BACKUP")

;#************************************************************************** 
;#	5.0	Final Constraints
;#
;#		None
;#
;#**************************************************************************
ENDPROC