PROC H_FL_ECAL_1
;version 4
GOTO BEGIN
;
;#**************************************************************************
;#	****PROCEDURE HEADER****
;#
;# 	1.0 	Introduction
;#
;#		1.1	FOT Name: H_FL_ECAL_1  
;#		   	MMS-F Name: H_FL_ECAL_1 	 
;#		   	SUM Issue: N/A	
;#			Simulator Validation Status: Validated
;#
;#		1.2	Date Created:  7 MAR 1995    TL
;#			    Revision:  1) 5 APR 1995    TL
;#                            2) 27 APR 1995   TL
;#                            3) 11 AUG 1995   TL
;#                            4) 25 Oct 1995   TL
;#
;#		1.3	Change Description:	
;#
;#			1) Added two wait statements.
;#             2) Removed wait statement, added another. (4/27)
;#             3) Recoded commands and parameters.
;#             4) Added version number, comments.
;#
;#		1.4	Point of Contact: T. LA FAVE	
;#			FOT Author: T. LA FAVE 	ATSC/SOHO	286-4799
;#
;#**************************************************************************
;#	2.0	Description
;#
;#		2.1	Narrative Description
;#
;#			This module will test transition from ON mode to
;#             CALIBRATE mode and back, and run a short calibration
;#             sequence, thus verifying function of related commands.
;#             Will calibrate HED high gain H1 channels, LED D1i
;#             (i = 1,3,5,7) and D2 high gain channels.
;#
;#		2.2	Intended Use:
;#
;#			
;#
;#		2.3	Duration:	100 min.
;#
;#		2.4 References:
;#             Page h_cepac1
;#**************************************************************************
;#	3.0	Instructions for Use:
;#
;#		3.1	Parameters Required
;#
;#			None
;#
;#		3.2	Critical Activities
;#
;#			None
;#
;#		3.3	Special Constraints or Activities
;#
;#			None
;#**************************************************************************
;#	4.0	STEPS:

BEGIN:

IF (P@CMD_STATE#TELECOMMAND = "AVAILABLE") THEN
ELSE
	/CLEAR		;Clearing the Command Buffer.
ENDIF

WAIT UNTIL (P@HSEMODE = "MAINTENANCE")

/HBEUPLD3,4CA2,ED6A,C400   ;Data upload
/HBEHCAL            ;Start HED calibration sequence
WAIT                ;Verify command buffer contents
/SEND

WAIT UNTIL (P@HSEMODE = "CALIB")
WAIT 60
WAIT UNTIL (P@HSEMODE = "MAINTENANCE")
WAIT UNTIL (P@CMD_STATE = "AVAILABLE")
/HBEUPLD3,4CA2,ED6A,C400   ;Data upload
/HBELCAL            ;Start LED calibration sequence
WAIT                ;Verify command buffer contents
/SEND

WAIT UNTIL (P@HSEMODE = "CALIB")

WAIT 60
WAIT UNTIL (P@HSEMODE = "MAINTENANCE")

;#************************************************************************** 
;#	5.0	Final Constraints
;#
;#		None
;#
;#**************************************************************************
ENDPROC