PROC H_FL_EINITOBS
;version 2
GOTO BEGIN
;
;#**************************************************************************
;#	****PROCEDURE HEADER****
;#
;# 	1.0 	Introduction
;#
;#		1.1	FOT Name: H_FL_EINITOBS    
;#		   	MMS-F Name: H_FL_EINITOBS 	 
;#		   	SUM Issue: N/A
;#			Simulator Validation Status: Validated
;#
;#		1.2	Date Created: 7 MAR 1995    TL 
;#			    Revision: 1) 19 Sept 95  TL 
;#                           2) 25 Oct 95  TL
;#
;#		1.3	Change Description:	
;#
;#			1) Changed name to EINITOBS, updated header.
;#             2) Added version number, comments.
;#
;#		1.4	Point of Contact: T. LA FAVE	
;#			FOT Author: T. LA FAVE 	ATSC/SOHO	286-4799
;#
;#**************************************************************************
;#	2.0	Description
;#
;#		2.1	Narrative Description
;#
;#			This procedure is used to switch ESU from STANDBY mode to 
;#             ON mode (nominal observation mode).  The module is self-
;#             standing and can be used independently whenever this
;#             transition is necessary.
;#
;#		2.2	Intended Use:
;#
;#			
;#
;#		2.3	Duration:	4 min.
;#
;#		2.4 References:
;#             Page h_cepac1
;#
;#**************************************************************************
;#	3.0	Instructions for Use:
;#
;#		3.1	Parameters Required
;#
;#			None
;#
;#		3.2	Critical Activities
;#
;#			None
;#
;#		3.3	Special Constraints or Activities
;#
;#			None
;#**************************************************************************
;#	4.0	STEPS:

BEGIN:

IF (P@CMD_STATE#TELECOMMAND = "AVAILABLE") THEN
ELSE
	/CLEAR		;Clearing the Command Buffer.
ENDIF

WAIT UNTIL (P@HSEMODE = "STANDBY")
/HBEUPLD3,4CA2,9C00,0000  ; Upload data
/HBEOMODE                 ; Enter ESU ON mode
WAIT                      ;Verify command buffer contents
/SEND

WAIT UNTIL (P@HSEMODE = "ON")

;#************************************************************************** 
;#	5.0	Final Constraints
;#
;#		None
;#
;#**************************************************************************
ENDPROC